Calculators / Resistor color code

18 Ω resistor color code

A 18 Ω resistor is brown, grey, black, gold on a 4-band resistor and brown, grey, black, gold, brown on a 5-band resistor. The colour code is the same everywhere; only the spelling differs.

4 bands, ±5%
Brown, grey, black, gold
5 bands, ±1%
Brown, grey, black, gold, brown

Reading the bands

On the 4-band resistor, brown (1) and grey (8) are the digits and black is the multiplier, so 18 × 1 = 18 Ω; gold is ±5%. The 5-band version uses three digits and one fewer zero, and its last band, brown, is ±1%.

A 18 Ω resistor on common supplies

Straight across the supply, with nothing else in the circuit:

SupplyCurrentPowerRating needed
3.3 V183 mA605 mW2 W
5 V278 mA1.39 Wmore than 2 W: use a bigger resistor or a lower current
9 V500 mA4.5 Wmore than 2 W: use a bigger resistor or a lower current
12 V667 mA8 Wmore than 2 W: use a bigger resistor or a lower current

What it is used for

Common as MOSFET gate resistors (10 to 100 Ω), series resistors that damp ringing on fast signal lines, and LED resistors on 3.3 V or for high-current LEDs.

Try it live

The calculator is set to this resistor. Change any band to read another value; the circuit below the answer runs it on 5 V.

Resistance18 Ω
Tolerance±5%
Actual value is between17.1 Ω and 18.9 Ω
Current on 5 V278 mA
The circuit, running liveOpen in the playground →

The resistor sits across a 5 V supply with an ammeter, so you can see the current its value allows: I = 5 V ÷ R.

Printable resistor color code chart

Every band, the multipliers and tolerances, and the common values drawn, on one A4 page. We email you the PDF.

We only use your address for what you ticked. See our privacy policy.

Questions

What color is a 18 Ω resistor?

Brown, grey, black, gold on a 4-band resistor (±5%), and brown, grey, black, gold, brown on a 5-band resistor (±1%).

How do I check a 18 Ω resistor?

Measure it out of the circuit with a multimeter on the resistance range. A ±5% part reads between 17.1 Ω and 18.9 Ω; a ±1% part between 17.8 Ω and 18.2 Ω.

What can I use instead of a 18 Ω resistor?

The nearest standard values are 15 Ω and 22 Ω; for LED resistors and pull-ups either usually works. For something in between, put two resistors in series (the values add) or in parallel; the series and parallel calculator works out the total.