Calculators / Resistor color code

330 kΩ resistor color code

A 330 kΩ resistor is orange, orange, yellow, gold on a 4-band resistor and orange, orange, black, orange, brown on a 5-band resistor. The colour code is the same everywhere; only the spelling differs.

4 bands, ±5%
Orange, orange, yellow, gold
5 bands, ±1%
Orange, orange, black, orange, brown

Reading the bands

On the 4-band resistor, orange (3) and orange (3) are the digits and yellow is the multiplier, so 33 × 10,000 = 330 kΩ; gold is ±5%. The 5-band version uses three digits and one fewer zero, and its last band, brown, is ±1%.

A 330 kΩ resistor on common supplies

Straight across the supply, with nothing else in the circuit:

SupplyCurrentPowerRating needed
3.3 V10 µA33 µW1/8 W
5 V15.2 µA75.8 µW1/8 W
9 V27.3 µA245 µW1/8 W
12 V36.4 µA436 µW1/8 W

What it is used for

Used where very little current should flow: battery-voltage dividers into an ADC, op-amp feedback and input resistors, and long RC time constants.

Try it live

The calculator is set to this resistor. Change any band to read another value; the circuit below the answer runs it on 5 V.

Resistance330 kΩ
Tolerance±5%
Actual value is between314 kΩ and 347 kΩ
Current on 5 V15.2 µA
The circuit, running liveOpen in the playground →

The resistor sits across a 5 V supply with an ammeter, so you can see the current its value allows: I = 5 V ÷ R.

Printable resistor color code chart

Every band, the multipliers and tolerances, and the common values drawn, on one A4 page. We email you the PDF.

We only use your address for what you ticked. See our privacy policy.

Questions

What color is a 330 kΩ resistor?

Orange, orange, yellow, gold on a 4-band resistor (±5%), and orange, orange, black, orange, brown on a 5-band resistor (±1%).

How do I check a 330 kΩ resistor?

Measure it out of the circuit with a multimeter on the resistance range. A ±5% part reads between 314 kΩ and 347 kΩ; a ±1% part between 327 kΩ and 333 kΩ.

What can I use instead of a 330 kΩ resistor?

The nearest standard values are 270 kΩ and 390 kΩ; for LED resistors and pull-ups either usually works. For something in between, put two resistors in series (the values add) or in parallel; the series and parallel calculator works out the total.