Calculators / Resistor color code

39 kΩ resistor color code

A 39 kΩ resistor is orange, white, orange, gold on a 4-band resistor and orange, white, black, red, brown on a 5-band resistor. The colour code is the same everywhere; only the spelling differs.

4 bands, ±5%
Orange, white, orange, gold
5 bands, ±1%
Orange, white, black, red, brown

Reading the bands

On the 4-band resistor, orange (3) and white (9) are the digits and orange is the multiplier, so 39 × 1,000 = 39 kΩ; gold is ±5%. The 5-band version uses three digits and one fewer zero, and its last band, brown, is ±1%.

A 39 kΩ resistor on common supplies

Straight across the supply, with nothing else in the circuit:

SupplyCurrentPowerRating needed
3.3 V84.6 µA279 µW1/8 W
5 V128 µA641 µW1/8 W
9 V231 µA2.08 mW1/8 W
12 V308 µA3.69 mW1/8 W

What it is used for

The standard range for pull-up and pull-down resistors (10 kΩ is the classic), op-amp gain resistors, and RC timing with small capacitors.

Try it live

The calculator is set to this resistor. Change any band to read another value; the circuit below the answer runs it on 5 V.

Resistance39 kΩ
Tolerance±5%
Actual value is between37.1 kΩ and 41 kΩ
Current on 5 V128 µA
The circuit, running liveOpen in the playground →

The resistor sits across a 5 V supply with an ammeter, so you can see the current its value allows: I = 5 V ÷ R.

Printable resistor color code chart

Every band, the multipliers and tolerances, and the common values drawn, on one A4 page. We email you the PDF.

We only use your address for what you ticked. See our privacy policy.

Questions

What color is a 39 kΩ resistor?

Orange, white, orange, gold on a 4-band resistor (±5%), and orange, white, black, red, brown on a 5-band resistor (±1%).

How do I check a 39 kΩ resistor?

Measure it out of the circuit with a multimeter on the resistance range. A ±5% part reads between 37.1 kΩ and 41 kΩ; a ±1% part between 38.6 kΩ and 39.4 kΩ.

What can I use instead of a 39 kΩ resistor?

The nearest standard values are 33 kΩ and 47 kΩ; for LED resistors and pull-ups either usually works. For something in between, put two resistors in series (the values add) or in parallel; the series and parallel calculator works out the total.