Calculators / Resistor color code
4.7 Ω resistor color code
A 4.7 Ω resistor is yellow, violet, gold, gold on a 4-band resistor and yellow, violet, black, silver, brown on a 5-band resistor. The colour code is the same everywhere; only the spelling differs.
Reading the bands
On the 4-band resistor, yellow (4) and violet (7) are the digits and gold is the multiplier, so 47 × 0.1 = 4.7 Ω; gold is ±5%. The 5-band version uses three digits and one fewer zero, and its last band, brown, is ±1%.
A 4.7 Ω resistor on common supplies
Straight across the supply, with nothing else in the circuit:
| Supply | Current | Power | Rating needed |
|---|---|---|---|
| 3.3 V | 702 mA | 2.32 W | more than 2 W: use a bigger resistor or a lower current |
| 5 V | 1.06 A | 5.32 W | more than 2 W: use a bigger resistor or a lower current |
| 9 V | 1.91 A | 17.2 W | more than 2 W: use a bigger resistor or a lower current |
| 12 V | 2.55 A | 30.6 W | more than 2 W: use a bigger resistor or a lower current |
What it is used for
Values this low sense current (a shunt: the voltage across it shows the current through it), limit inrush current, or act as a cheap fuse. Straight across a supply they pass large currents, so check the power rating.
Try it live
The calculator is set to this resistor. Change any band to read another value; the circuit below the answer runs it on 5 V.
| Resistance | 4.7 Ω |
|---|---|
| Tolerance | ±5% |
| Actual value is between | 4.47 Ω and 4.94 Ω |
| Current on 5 V | 1.06 A |
Printable resistor color code chart
Questions
What color is a 4.7 Ω resistor?
Yellow, violet, gold, gold on a 4-band resistor (±5%), and yellow, violet, black, silver, brown on a 5-band resistor (±1%).
How do I check a 4.7 Ω resistor?
Measure it out of the circuit with a multimeter on the resistance range. A ±5% part reads between 4.46 Ω and 4.94 Ω; a ±1% part between 4.65 Ω and 4.75 Ω.
What can I use instead of a 4.7 Ω resistor?
The nearest standard values are 3.9 Ω and 5.6 Ω; for LED resistors and pull-ups either usually works. For something in between, put two resistors in series (the values add) or in parallel; the series and parallel calculator works out the total.