Calculators / Resistor color code

56 kΩ resistor color code

A 56 kΩ resistor is green, blue, orange, gold on a 4-band resistor and green, blue, black, red, brown on a 5-band resistor. The colour code is the same everywhere; only the spelling differs.

4 bands, ±5%
Green, blue, orange, gold
5 bands, ±1%
Green, blue, black, red, brown

Reading the bands

On the 4-band resistor, green (5) and blue (6) are the digits and orange is the multiplier, so 56 × 1,000 = 56 kΩ; gold is ±5%. The 5-band version uses three digits and one fewer zero, and its last band, brown, is ±1%.

A 56 kΩ resistor on common supplies

Straight across the supply, with nothing else in the circuit:

SupplyCurrentPowerRating needed
3.3 V58.9 µA194 µW1/8 W
5 V89.3 µA446 µW1/8 W
9 V161 µA1.45 mW1/8 W
12 V214 µA2.57 mW1/8 W

What it is used for

The standard range for pull-up and pull-down resistors (10 kΩ is the classic), op-amp gain resistors, and RC timing with small capacitors.

Try it live

The calculator is set to this resistor. Change any band to read another value; the circuit below the answer runs it on 5 V.

Resistance56 kΩ
Tolerance±5%
Actual value is between53.2 kΩ and 58.8 kΩ
Current on 5 V89.3 µA
The circuit, running liveOpen in the playground →

The resistor sits across a 5 V supply with an ammeter, so you can see the current its value allows: I = 5 V ÷ R.

Printable resistor color code chart

Every band, the multipliers and tolerances, and the common values drawn, on one A4 page. We email you the PDF.

We only use your address for what you ticked. See our privacy policy.

Questions

What color is a 56 kΩ resistor?

Green, blue, orange, gold on a 4-band resistor (±5%), and green, blue, black, red, brown on a 5-band resistor (±1%).

How do I check a 56 kΩ resistor?

Measure it out of the circuit with a multimeter on the resistance range. A ±5% part reads between 53.2 kΩ and 58.8 kΩ; a ±1% part between 55.4 kΩ and 56.6 kΩ.

What can I use instead of a 56 kΩ resistor?

The nearest standard values are 47 kΩ and 68 kΩ; for LED resistors and pull-ups either usually works. For something in between, put two resistors in series (the values add) or in parallel; the series and parallel calculator works out the total.