Calculators / Resistor color code

560 kΩ resistor color code

A 560 kΩ resistor is green, blue, yellow, gold on a 4-band resistor and green, blue, black, orange, brown on a 5-band resistor. The colour code is the same everywhere; only the spelling differs.

4 bands, ±5%
Green, blue, yellow, gold
5 bands, ±1%
Green, blue, black, orange, brown

Reading the bands

On the 4-band resistor, green (5) and blue (6) are the digits and yellow is the multiplier, so 56 × 10,000 = 560 kΩ; gold is ±5%. The 5-band version uses three digits and one fewer zero, and its last band, brown, is ±1%.

A 560 kΩ resistor on common supplies

Straight across the supply, with nothing else in the circuit:

SupplyCurrentPowerRating needed
3.3 V5.89 µA19.4 µW1/8 W
5 V8.93 µA44.6 µW1/8 W
9 V16.1 µA145 µW1/8 W
12 V21.4 µA257 µW1/8 W

What it is used for

Used where very little current should flow: battery-voltage dividers into an ADC, op-amp feedback and input resistors, and long RC time constants.

Try it live

The calculator is set to this resistor. Change any band to read another value; the circuit below the answer runs it on 5 V.

Resistance560 kΩ
Tolerance±5%
Actual value is between532 kΩ and 588 kΩ
Current on 5 V8.93 µA
The circuit, running liveOpen in the playground →

The resistor sits across a 5 V supply with an ammeter, so you can see the current its value allows: I = 5 V ÷ R.

Printable resistor color code chart

Every band, the multipliers and tolerances, and the common values drawn, on one A4 page. We email you the PDF.

We only use your address for what you ticked. See our privacy policy.

Questions

What color is a 560 kΩ resistor?

Green, blue, yellow, gold on a 4-band resistor (±5%), and green, blue, black, orange, brown on a 5-band resistor (±1%).

How do I check a 560 kΩ resistor?

Measure it out of the circuit with a multimeter on the resistance range. A ±5% part reads between 532 kΩ and 588 kΩ; a ±1% part between 554 kΩ and 566 kΩ.

What can I use instead of a 560 kΩ resistor?

The nearest standard values are 470 kΩ and 680 kΩ; for LED resistors and pull-ups either usually works. For something in between, put two resistors in series (the values add) or in parallel; the series and parallel calculator works out the total.