Calculators / Resistor color code

100 Ω resistor color code

A 100 Ω resistor is brown, black, brown, gold on a 4-band resistor and brown, black, black, black, brown on a 5-band resistor. The colour code is the same everywhere; only the spelling differs.

4 bands, ±5%
Brown, black, brown, gold
5 bands, ±1%
Brown, black, black, black, brown

Reading the bands

On the 4-band resistor, brown (1) and black (0) are the digits and brown is the multiplier, so 10 × 10 = 100 Ω; gold is ±5%. The 5-band version uses three digits and one fewer zero, and its last band, brown, is ±1%.

A 100 Ω resistor on common supplies

Straight across the supply, with nothing else in the circuit:

SupplyCurrentPowerRating needed
3.3 V33 mA109 mW1/4 W
5 V50 mA250 mW1/2 W
9 V90 mA810 mW2 W
12 V120 mA1.44 Wmore than 2 W: use a bigger resistor or a lower current

As an LED resistor on 5 V it lets about 30 mA through a red LED (about 2 V). Work out an LED resistor.

What it is used for

The usual range for LED current-limiting resistors on 5 V (220 to 470 Ω gives about 6 to 14 mA through a red LED), and for base resistors switching small loads.

Try it live

The calculator is set to this resistor. Change any band to read another value; the circuit below the answer runs it on 5 V.

Resistance100 Ω
Tolerance±5%
Actual value is between95 Ω and 105 Ω
Current on 5 V50 mA
The circuit, running liveOpen in the playground →

The resistor sits across a 5 V supply with an ammeter, so you can see the current its value allows: I = 5 V ÷ R.

Printable resistor color code chart

Every band, the multipliers and tolerances, and the common values drawn, on one A4 page. We email you the PDF.

We only use your address for what you ticked. See our privacy policy.

Questions

What color is a 100 Ω resistor?

Brown, black, brown, gold on a 4-band resistor (±5%), and brown, black, black, black, brown on a 5-band resistor (±1%).

How do I check a 100 Ω resistor?

Measure it out of the circuit with a multimeter on the resistance range. A ±5% part reads between 95 Ω and 105 Ω; a ±1% part between 99 Ω and 101 Ω.

What can I use instead of a 100 Ω resistor?

The nearest standard values are 82 Ω and 120 Ω; for LED resistors and pull-ups either usually works. For something in between, put two resistors in series (the values add) or in parallel; the series and parallel calculator works out the total.