Calculators / Resistor color code

120 Ω resistor color code

A 120 Ω resistor is brown, red, brown, gold on a 4-band resistor and brown, red, black, black, brown on a 5-band resistor. The colour code is the same everywhere; only the spelling differs.

4 bands, ±5%
Brown, red, brown, gold
5 bands, ±1%
Brown, red, black, black, brown

Reading the bands

On the 4-band resistor, brown (1) and red (2) are the digits and brown is the multiplier, so 12 × 10 = 120 Ω; gold is ±5%. The 5-band version uses three digits and one fewer zero, and its last band, brown, is ±1%.

A 120 Ω resistor on common supplies

Straight across the supply, with nothing else in the circuit:

SupplyCurrentPowerRating needed
3.3 V27.5 mA90.8 mW1/4 W
5 V41.7 mA208 mW1/2 W
9 V75 mA675 mW2 W
12 V100 mA1.2 Wmore than 2 W: use a bigger resistor or a lower current

As an LED resistor on 5 V it lets about 25 mA through a red LED (about 2 V). Work out an LED resistor.

What it is used for

The usual range for LED current-limiting resistors on 5 V (220 to 470 Ω gives about 6 to 14 mA through a red LED), and for base resistors switching small loads.

Try it live

The calculator is set to this resistor. Change any band to read another value; the circuit below the answer runs it on 5 V.

Resistance120 Ω
Tolerance±5%
Actual value is between114 Ω and 126 Ω
Current on 5 V41.7 mA
The circuit, running liveOpen in the playground →

The resistor sits across a 5 V supply with an ammeter, so you can see the current its value allows: I = 5 V ÷ R.

Printable resistor color code chart

Every band, the multipliers and tolerances, and the common values drawn, on one A4 page. We email you the PDF.

We only use your address for what you ticked. See our privacy policy.

Questions

What color is a 120 Ω resistor?

Brown, red, brown, gold on a 4-band resistor (±5%), and brown, red, black, black, brown on a 5-band resistor (±1%).

How do I check a 120 Ω resistor?

Measure it out of the circuit with a multimeter on the resistance range. A ±5% part reads between 114 Ω and 126 Ω; a ±1% part between 119 Ω and 121 Ω.

What can I use instead of a 120 Ω resistor?

The nearest standard values are 100 Ω and 150 Ω; for LED resistors and pull-ups either usually works. For something in between, put two resistors in series (the values add) or in parallel; the series and parallel calculator works out the total.