Calculators / Resistor color code

100 kΩ resistor color code

A 100 kΩ resistor is brown, black, yellow, gold on a 4-band resistor and brown, black, black, orange, brown on a 5-band resistor. The colour code is the same everywhere; only the spelling differs.

4 bands, ±5%
Brown, black, yellow, gold
5 bands, ±1%
Brown, black, black, orange, brown

Reading the bands

On the 4-band resistor, brown (1) and black (0) are the digits and yellow is the multiplier, so 10 × 10,000 = 100 kΩ; gold is ±5%. The 5-band version uses three digits and one fewer zero, and its last band, brown, is ±1%.

A 100 kΩ resistor on common supplies

Straight across the supply, with nothing else in the circuit:

SupplyCurrentPowerRating needed
3.3 V33 µA109 µW1/8 W
5 V50 µA250 µW1/8 W
9 V90 µA810 µW1/8 W
12 V120 µA1.44 mW1/8 W

What it is used for

A common choice for battery-voltage dividers into a microcontroller's ADC: two 100 kΩ resistors halve the voltage and waste only a few microamps.

Used where very little current should flow: battery-voltage dividers into an ADC, op-amp feedback and input resistors, and long RC time constants.

Try it live

The calculator is set to this resistor. Change any band to read another value; the circuit below the answer runs it on 5 V.

Resistance100 kΩ
Tolerance±5%
Actual value is between95 kΩ and 105 kΩ
Current on 5 V50 µA
The circuit, running liveOpen in the playground →

The resistor sits across a 5 V supply with an ammeter, so you can see the current its value allows: I = 5 V ÷ R.

Printable resistor color code chart

Every band, the multipliers and tolerances, and the common values drawn, on one A4 page. We email you the PDF.

We only use your address for what you ticked. See our privacy policy.

Questions

What color is a 100 kΩ resistor?

Brown, black, yellow, gold on a 4-band resistor (±5%), and brown, black, black, orange, brown on a 5-band resistor (±1%).

How do I check a 100 kΩ resistor?

Measure it out of the circuit with a multimeter on the resistance range. A ±5% part reads between 95 kΩ and 105 kΩ; a ±1% part between 99 kΩ and 101 kΩ.

What can I use instead of a 100 kΩ resistor?

The nearest standard values are 82 kΩ and 120 kΩ; for LED resistors and pull-ups either usually works. For something in between, put two resistors in series (the values add) or in parallel; the series and parallel calculator works out the total.