Calculators / Resistor color code

120 kΩ resistor color code

A 120 kΩ resistor is brown, red, yellow, gold on a 4-band resistor and brown, red, black, orange, brown on a 5-band resistor. The colour code is the same everywhere; only the spelling differs.

4 bands, ±5%
Brown, red, yellow, gold
5 bands, ±1%
Brown, red, black, orange, brown

Reading the bands

On the 4-band resistor, brown (1) and red (2) are the digits and yellow is the multiplier, so 12 × 10,000 = 120 kΩ; gold is ±5%. The 5-band version uses three digits and one fewer zero, and its last band, brown, is ±1%.

A 120 kΩ resistor on common supplies

Straight across the supply, with nothing else in the circuit:

SupplyCurrentPowerRating needed
3.3 V27.5 µA90.8 µW1/8 W
5 V41.7 µA208 µW1/8 W
9 V75 µA675 µW1/8 W
12 V100 µA1.2 mW1/8 W

What it is used for

Used where very little current should flow: battery-voltage dividers into an ADC, op-amp feedback and input resistors, and long RC time constants.

Try it live

The calculator is set to this resistor. Change any band to read another value; the circuit below the answer runs it on 5 V.

Resistance120 kΩ
Tolerance±5%
Actual value is between114 kΩ and 126 kΩ
Current on 5 V41.7 µA
The circuit, running liveOpen in the playground →

The resistor sits across a 5 V supply with an ammeter, so you can see the current its value allows: I = 5 V ÷ R.

Printable resistor color code chart

Every band, the multipliers and tolerances, and the common values drawn, on one A4 page. We email you the PDF.

We only use your address for what you ticked. See our privacy policy.

Questions

What color is a 120 kΩ resistor?

Brown, red, yellow, gold on a 4-band resistor (±5%), and brown, red, black, orange, brown on a 5-band resistor (±1%).

How do I check a 120 kΩ resistor?

Measure it out of the circuit with a multimeter on the resistance range. A ±5% part reads between 114 kΩ and 126 kΩ; a ±1% part between 119 kΩ and 121 kΩ.

What can I use instead of a 120 kΩ resistor?

The nearest standard values are 100 kΩ and 150 kΩ; for LED resistors and pull-ups either usually works. For something in between, put two resistors in series (the values add) or in parallel; the series and parallel calculator works out the total.