Calculators / Resistor color code

1.5 kΩ resistor color code

A 1.5 kΩ resistor is brown, green, red, gold on a 4-band resistor and brown, green, black, brown, brown on a 5-band resistor. The colour code is the same everywhere; only the spelling differs.

4 bands, ±5%
Brown, green, red, gold
5 bands, ±1%
Brown, green, black, brown, brown

Reading the bands

On the 4-band resistor, brown (1) and green (5) are the digits and red is the multiplier, so 15 × 100 = 1.5 kΩ; gold is ±5%. The 5-band version uses three digits and one fewer zero, and its last band, brown, is ±1%.

A 1.5 kΩ resistor on common supplies

Straight across the supply, with nothing else in the circuit:

SupplyCurrentPowerRating needed
3.3 V2.2 mA7.26 mW1/8 W
5 V3.33 mA16.7 mW1/8 W
9 V6 mA54 mW1/8 W
12 V8 mA96 mW1/4 W

As an LED resistor on 5 V it lets about 2.0 mA through a red LED (about 2 V). Work out an LED resistor.

What it is used for

Everyday values for transistor base resistors, LED resistors on 9 V and 12 V, voltage dividers, and pull-ups (4.7 kΩ is the usual I²C pull-up).

Try it live

The calculator is set to this resistor. Change any band to read another value; the circuit below the answer runs it on 5 V.

Resistance1.5 kΩ
Tolerance±5%
Actual value is between1.43 kΩ and 1.58 kΩ
Current on 5 V3.33 mA
The circuit, running liveOpen in the playground →

The resistor sits across a 5 V supply with an ammeter, so you can see the current its value allows: I = 5 V ÷ R.

Printable resistor color code chart

Every band, the multipliers and tolerances, and the common values drawn, on one A4 page. We email you the PDF.

We only use your address for what you ticked. See our privacy policy.

Questions

What color is a 1.5 kΩ resistor?

Brown, green, red, gold on a 4-band resistor (±5%), and brown, green, black, brown, brown on a 5-band resistor (±1%).

How do I check a 1.5 kΩ resistor?

Measure it out of the circuit with a multimeter on the resistance range. A ±5% part reads between 1.43 kΩ and 1.58 kΩ; a ±1% part between 1.49 kΩ and 1.52 kΩ.

What can I use instead of a 1.5 kΩ resistor?

The nearest standard values are 1.2 kΩ and 1.8 kΩ; for LED resistors and pull-ups either usually works. For something in between, put two resistors in series (the values add) or in parallel; the series and parallel calculator works out the total.