Calculators / Resistor color code

15 kΩ resistor color code

A 15 kΩ resistor is brown, green, orange, gold on a 4-band resistor and brown, green, black, red, brown on a 5-band resistor. The colour code is the same everywhere; only the spelling differs.

4 bands, ±5%
Brown, green, orange, gold
5 bands, ±1%
Brown, green, black, red, brown

Reading the bands

On the 4-band resistor, brown (1) and green (5) are the digits and orange is the multiplier, so 15 × 1,000 = 15 kΩ; gold is ±5%. The 5-band version uses three digits and one fewer zero, and its last band, brown, is ±1%.

A 15 kΩ resistor on common supplies

Straight across the supply, with nothing else in the circuit:

SupplyCurrentPowerRating needed
3.3 V220 µA726 µW1/8 W
5 V333 µA1.67 mW1/8 W
9 V600 µA5.4 mW1/8 W
12 V800 µA9.6 mW1/8 W

What it is used for

The standard range for pull-up and pull-down resistors (10 kΩ is the classic), op-amp gain resistors, and RC timing with small capacitors.

Try it live

The calculator is set to this resistor. Change any band to read another value; the circuit below the answer runs it on 5 V.

Resistance15 kΩ
Tolerance±5%
Actual value is between14.3 kΩ and 15.8 kΩ
Current on 5 V333 µA
The circuit, running liveOpen in the playground →

The resistor sits across a 5 V supply with an ammeter, so you can see the current its value allows: I = 5 V ÷ R.

Printable resistor color code chart

Every band, the multipliers and tolerances, and the common values drawn, on one A4 page. We email you the PDF.

We only use your address for what you ticked. See our privacy policy.

Questions

What color is a 15 kΩ resistor?

Brown, green, orange, gold on a 4-band resistor (±5%), and brown, green, black, red, brown on a 5-band resistor (±1%).

How do I check a 15 kΩ resistor?

Measure it out of the circuit with a multimeter on the resistance range. A ±5% part reads between 14.3 kΩ and 15.8 kΩ; a ±1% part between 14.9 kΩ and 15.2 kΩ.

What can I use instead of a 15 kΩ resistor?

The nearest standard values are 12 kΩ and 18 kΩ; for LED resistors and pull-ups either usually works. For something in between, put two resistors in series (the values add) or in parallel; the series and parallel calculator works out the total.