Calculators / Resistor color code

180 kΩ resistor color code

A 180 kΩ resistor is brown, grey, yellow, gold on a 4-band resistor and brown, grey, black, orange, brown on a 5-band resistor. The colour code is the same everywhere; only the spelling differs.

4 bands, ±5%
Brown, grey, yellow, gold
5 bands, ±1%
Brown, grey, black, orange, brown

Reading the bands

On the 4-band resistor, brown (1) and grey (8) are the digits and yellow is the multiplier, so 18 × 10,000 = 180 kΩ; gold is ±5%. The 5-band version uses three digits and one fewer zero, and its last band, brown, is ±1%.

A 180 kΩ resistor on common supplies

Straight across the supply, with nothing else in the circuit:

SupplyCurrentPowerRating needed
3.3 V18.3 µA60.5 µW1/8 W
5 V27.8 µA139 µW1/8 W
9 V50 µA450 µW1/8 W
12 V66.7 µA800 µW1/8 W

What it is used for

Used where very little current should flow: battery-voltage dividers into an ADC, op-amp feedback and input resistors, and long RC time constants.

Try it live

The calculator is set to this resistor. Change any band to read another value; the circuit below the answer runs it on 5 V.

Resistance180 kΩ
Tolerance±5%
Actual value is between171 kΩ and 189 kΩ
Current on 5 V27.8 µA
The circuit, running liveOpen in the playground →

The resistor sits across a 5 V supply with an ammeter, so you can see the current its value allows: I = 5 V ÷ R.

Printable resistor color code chart

Every band, the multipliers and tolerances, and the common values drawn, on one A4 page. We email you the PDF.

We only use your address for what you ticked. See our privacy policy.

Questions

What color is a 180 kΩ resistor?

Brown, grey, yellow, gold on a 4-band resistor (±5%), and brown, grey, black, orange, brown on a 5-band resistor (±1%).

How do I check a 180 kΩ resistor?

Measure it out of the circuit with a multimeter on the resistance range. A ±5% part reads between 171 kΩ and 189 kΩ; a ±1% part between 178 kΩ and 182 kΩ.

What can I use instead of a 180 kΩ resistor?

The nearest standard values are 150 kΩ and 220 kΩ; for LED resistors and pull-ups either usually works. For something in between, put two resistors in series (the values add) or in parallel; the series and parallel calculator works out the total.