Calculators / Resistor color code

220 kΩ resistor color code

A 220 kΩ resistor is red, red, yellow, gold on a 4-band resistor and red, red, black, orange, brown on a 5-band resistor. The colour code is the same everywhere; only the spelling differs.

4 bands, ±5%
Red, red, yellow, gold
5 bands, ±1%
Red, red, black, orange, brown

Reading the bands

On the 4-band resistor, red (2) and red (2) are the digits and yellow is the multiplier, so 22 × 10,000 = 220 kΩ; gold is ±5%. The 5-band version uses three digits and one fewer zero, and its last band, brown, is ±1%.

A 220 kΩ resistor on common supplies

Straight across the supply, with nothing else in the circuit:

SupplyCurrentPowerRating needed
3.3 V15 µA49.5 µW1/8 W
5 V22.7 µA114 µW1/8 W
9 V40.9 µA368 µW1/8 W
12 V54.5 µA655 µW1/8 W

What it is used for

Used where very little current should flow: battery-voltage dividers into an ADC, op-amp feedback and input resistors, and long RC time constants.

Try it live

The calculator is set to this resistor. Change any band to read another value; the circuit below the answer runs it on 5 V.

Resistance220 kΩ
Tolerance±5%
Actual value is between209 kΩ and 231 kΩ
Current on 5 V22.7 µA
The circuit, running liveOpen in the playground →

The resistor sits across a 5 V supply with an ammeter, so you can see the current its value allows: I = 5 V ÷ R.

Printable resistor color code chart

Every band, the multipliers and tolerances, and the common values drawn, on one A4 page. We email you the PDF.

We only use your address for what you ticked. See our privacy policy.

Questions

What color is a 220 kΩ resistor?

Red, red, yellow, gold on a 4-band resistor (±5%), and red, red, black, orange, brown on a 5-band resistor (±1%).

How do I check a 220 kΩ resistor?

Measure it out of the circuit with a multimeter on the resistance range. A ±5% part reads between 209 kΩ and 231 kΩ; a ±1% part between 218 kΩ and 222 kΩ.

What can I use instead of a 220 kΩ resistor?

The nearest standard values are 180 kΩ and 270 kΩ; for LED resistors and pull-ups either usually works. For something in between, put two resistors in series (the values add) or in parallel; the series and parallel calculator works out the total.