Calculators / Resistor color code

27 Ω resistor color code

A 27 Ω resistor is red, violet, black, gold on a 4-band resistor and red, violet, black, gold, brown on a 5-band resistor. The colour code is the same everywhere; only the spelling differs.

4 bands, ±5%
Red, violet, black, gold
5 bands, ±1%
Red, violet, black, gold, brown

Reading the bands

On the 4-band resistor, red (2) and violet (7) are the digits and black is the multiplier, so 27 × 1 = 27 Ω; gold is ±5%. The 5-band version uses three digits and one fewer zero, and its last band, brown, is ±1%.

A 27 Ω resistor on common supplies

Straight across the supply, with nothing else in the circuit:

SupplyCurrentPowerRating needed
3.3 V122 mA403 mW1 W
5 V185 mA926 mW2 W
9 V333 mA3 Wmore than 2 W: use a bigger resistor or a lower current
12 V444 mA5.33 Wmore than 2 W: use a bigger resistor or a lower current

What it is used for

Common as MOSFET gate resistors (10 to 100 Ω), series resistors that damp ringing on fast signal lines, and LED resistors on 3.3 V or for high-current LEDs.

Try it live

The calculator is set to this resistor. Change any band to read another value; the circuit below the answer runs it on 5 V.

Resistance27 Ω
Tolerance±5%
Actual value is between25.7 Ω and 28.4 Ω
Current on 5 V185 mA
The circuit, running liveOpen in the playground →

The resistor sits across a 5 V supply with an ammeter, so you can see the current its value allows: I = 5 V ÷ R.

Printable resistor color code chart

Every band, the multipliers and tolerances, and the common values drawn, on one A4 page. We email you the PDF.

We only use your address for what you ticked. See our privacy policy.

Questions

What color is a 27 Ω resistor?

Red, violet, black, gold on a 4-band resistor (±5%), and red, violet, black, gold, brown on a 5-band resistor (±1%).

How do I check a 27 Ω resistor?

Measure it out of the circuit with a multimeter on the resistance range. A ±5% part reads between 25.6 Ω and 28.4 Ω; a ±1% part between 26.7 Ω and 27.3 Ω.

What can I use instead of a 27 Ω resistor?

The nearest standard values are 22 Ω and 33 Ω; for LED resistors and pull-ups either usually works. For something in between, put two resistors in series (the values add) or in parallel; the series and parallel calculator works out the total.