Calculators / Resistor color code

33 Ω resistor color code

A 33 Ω resistor is orange, orange, black, gold on a 4-band resistor and orange, orange, black, gold, brown on a 5-band resistor. The colour code is the same everywhere; only the spelling differs.

4 bands, ±5%
Orange, orange, black, gold
5 bands, ±1%
Orange, orange, black, gold, brown

Reading the bands

On the 4-band resistor, orange (3) and orange (3) are the digits and black is the multiplier, so 33 × 1 = 33 Ω; gold is ±5%. The 5-band version uses three digits and one fewer zero, and its last band, brown, is ±1%.

A 33 Ω resistor on common supplies

Straight across the supply, with nothing else in the circuit:

SupplyCurrentPowerRating needed
3.3 V100 mA330 mW1 W
5 V152 mA758 mW2 W
9 V273 mA2.45 Wmore than 2 W: use a bigger resistor or a lower current
12 V364 mA4.36 Wmore than 2 W: use a bigger resistor or a lower current

What it is used for

Common as MOSFET gate resistors (10 to 100 Ω), series resistors that damp ringing on fast signal lines, and LED resistors on 3.3 V or for high-current LEDs.

Try it live

The calculator is set to this resistor. Change any band to read another value; the circuit below the answer runs it on 5 V.

Resistance33 Ω
Tolerance±5%
Actual value is between31.4 Ω and 34.7 Ω
Current on 5 V152 mA
The circuit, running liveOpen in the playground →

The resistor sits across a 5 V supply with an ammeter, so you can see the current its value allows: I = 5 V ÷ R.

Printable resistor color code chart

Every band, the multipliers and tolerances, and the common values drawn, on one A4 page. We email you the PDF.

We only use your address for what you ticked. See our privacy policy.

Questions

What color is a 33 Ω resistor?

Orange, orange, black, gold on a 4-band resistor (±5%), and orange, orange, black, gold, brown on a 5-band resistor (±1%).

How do I check a 33 Ω resistor?

Measure it out of the circuit with a multimeter on the resistance range. A ±5% part reads between 31.3 Ω and 34.6 Ω; a ±1% part between 32.7 Ω and 33.3 Ω.

What can I use instead of a 33 Ω resistor?

The nearest standard values are 27 Ω and 39 Ω; for LED resistors and pull-ups either usually works. For something in between, put two resistors in series (the values add) or in parallel; the series and parallel calculator works out the total.