PCB trace width calculator
IPC-2221 gives the copper cross-section a current needs: A = (I ÷ (k × ΔT^0.44))^(1/0.725) square mils, with k = 0.048 for outer layers and 0.024 for inner layers. Divide by the copper thickness (1.378 mil per oz) for the width: 1 A with a 10 °C rise on 1 oz outer copper needs a 0.30 mm (12 mil) trace.
A = (I ÷ (k × ΔT^0.44))^(1/0.725)W = A ÷ (1.378 × oz)k = 0.048 outer, 0.024 inner| Trace width | 0.30 mm (11.8 mil) |
|---|---|
| Copper cross-section | 16.3 mil² |
| Trace resistance | 86.6 mΩ |
| Voltage drop | 86.6 mV |
| Power lost in the trace | 86.6 mW |
Worked example
1 A on an outer layer of 1 oz copper with a 10 °C rise: A = (1 ÷ (0.048 × 10^0.44))^1.379 = 16.3 mil², so W = 16.3 ÷ 1.378 = 11.8 mil, 0.30 mm. A 50 mm run of it measures 87 mΩ, so a 5 V load at the far end sees 4.91 V. The simulator shows the same drop.
Questions
What temperature rise should I use?
10 °C is the usual choice and keeps the board cool. 20 °C is common for power traces where space is tight. Go higher only if you know the board can take it.
Why are inner traces wider?
Inner layers are sealed in the laminate and shed heat far more slowly than outer traces cooled by the air, so IPC-2221 halves the current they may carry (k = 0.024 instead of 0.048).
What does 1 oz copper mean?
One ounce of copper spread over a square foot: a layer 35 µm (1.378 mil) thick. Most boards use 1 oz outer layers; 2 oz carries about twice the current for the same width.
Is IPC-2221 accurate?
It is conservative and widely used. The newer IPC-2152 accounts for the board and nearby copper and usually allows narrower traces, but needs more inputs. The formula covers currents up to about 35 A.
More calculators
- Resistor color code calculator
- LED resistor calculator
- Voltage divider calculator
- RC time constant calculator
- Ohm's law calculator
- Series and parallel resistor calculator
- Transistor base resistor calculator
- 555 timer calculator (astable)
- Battery life calculator
- RC filter calculator (low-pass)
- Capacitor code calculator
Want a whole circuit rather than one value? Describe it and the AI designs and simulates it.