RC filter calculator (low-pass)
An RC low-pass filter's cutoff frequency is fc = 1 ÷ (2π × R × C). At fc the output is 70.7% of the input (−3 dB); above it the output falls by half (−6 dB) for every doubling of frequency.
fc = 1 ÷ (2π × R × C)Vout ÷ Vin = 1 ÷ √(1 + (f ÷ fc)²)phase = −arctan(f ÷ fc)| Cutoff frequency (−3 dB) | 1.59 kHz |
|---|---|
| Output at 5 kHz | 30.3% of the input |
| In decibels | -10.4 dB |
| Phase shift | -72.3° |
Worked example
R = 1 kΩ and C = 100 nF: fc = 1 ÷ (2π × 1,000 × 0.0000001) = 1,592 Hz. A 5 kHz signal comes out at 1 ÷ √(1 + (5,000 ÷ 1,592)²) = 30.3%, which is −10.4 dB, 72° behind. In the simulator a 5 V sine wave comes out swinging ±1.52 V, as worked out.
Questions
How do I make a high-pass filter?
Swap the resistor and capacitor: the capacitor in series, the resistor to ground. The cutoff frequency formula is the same; it passes frequencies above fc instead of below.
Which resistor and capacitor should I pick?
Choose a capacitor value you have, then R = 1 ÷ (2π × fc × C). Keep R between about 1 kΩ and 100 kΩ: too low loads the source, too high and the next stage loads the filter.
How do I filter more steeply?
Two RC stages in a row fall at −12 dB per doubling, but the second stage loads the first, so make its resistor about 10 times bigger. For sharp filters use an active filter with an op-amp.
Can I smooth a PWM signal with this?
Yes: set fc well below the PWM frequency, say a tenth, and the output is close to the average voltage, with a little ripple.
More calculators
- Resistor color code calculator
- LED resistor calculator
- Voltage divider calculator
- RC time constant calculator
- Ohm's law calculator
- Series and parallel resistor calculator
- Transistor base resistor calculator
- 555 timer calculator (astable)
- PCB trace width calculator
- Battery life calculator
- Capacitor code calculator
Want a whole circuit rather than one value? Describe it and the AI designs and simulates it.